Installation, How to install, Fig. 8 – Kenmore 580.72184 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

INSTALLATION
INSTALLATION
Pick a location which will allow you to blow the cold
air into the area you want. Windows used for
installation must be strong enough to support the
weight of the air conditioner. Good installation with
special attention to the proper position of the unit
will lessen the chance that service will be needed.
When cooling more than one room, installation
location is very important since cold air will not turn
corners. To cool your rooms, cold air must be blown
from the air conditioner in a straight path.
HOW TO INSTALL
Remove the screws which fasten the cabinet at
the back and side of the unit. Save side screws.
Discard back screws.
Slide the unit out of the cabinet by gripping the
base pan handle and pull forward while bracing the
cabinet.
Cut the FOAM STRIP (ITEM J) to fit the
underside of the window sash. Peel off the backing
and attach the FOAM STRIP as shown In Fig. 5.
I Insert the side curtain (ITEM A) Into the upper guide
and lower guide of the air conditioner. Fasten the curtains
to the unit with screws (ITEM E).
window inner sill. Loosely attach the sill bracket (ITEM C)
to the support bracket (ITEM B) using the carriage bolt
(ITEM I) and the lock nut (ITEM D),
Lil Attach the sill bracket to the window sill using the
screws (ITEM F). Carefully place the cabinet on the
window inner sill and align the center mark on the
angle front with the center line marked on the window
inner sill.
Cabinet-
track hole
ITEMB—
Carriage bolt
and lock nut
^Machine screw
and lock nut
..Outer
edge of
window sill
ITEMF
Sill bracket
FIG. 8
U Using the M-screw (ITEM H) and the lock nut
(ITEM D), attach the support bracket to the cabinet
track hole. Use the first track hole after the sill bracket
on the outer edge of the window sill. Tighten the
carriage bolt and the lock nut. Be sure the cabinet
slants downward 1/4" from level.
CAUTION; Do not drill a hole in the bottom pan. The
unit is designed to operate with approximately 1/2" of
water in bottom pan.