Kenmore 580.75116 - Manual (Page 5)

INSTALLATION
Remove packing materials from the wall sleeve and tape
from the air conditioner.
INSTALLATION REQUIREMENTS
if you use an existing wail sieeve, you should
measure its dimensions.
Install the new air conditioner according to these
instailation instructions to achieve the best
performance. Ali wali sleeves used to mount the
new air conditioner must be in good structural
condition and have a rear grille to securely attach
the new air conditioner. {FIG. 1)
With the Kenmore sleeve, you can maintain the
best performance of the new air conditioner. (FIG.
2 )
24’(610niin)
INSTALLATION HARDWARE
Air Conditioner
18-’Vsa"{468 mm)
FIG. 1
ELECTRICAL SERVICE
Check your available electrical service. The power
supply available must be the same as that shown
on the unit nameplate {found on left side of cabinet).
All models are equipped with a 3-prong service plug
to provide proper service and safe positive
grounding. Do not change plug in any way. Do not
use an adapter plug. If your present wall outlet does
not match your plug, call a qualified electrician to
make the necessary corrections. SAVE CARTON
for storage and this OWNER'S MANUAL for future
reference. The carton Is the best way to store unit
during winter or when not in use.
nr>-'
2 Size options
Jlif (5
Cry-
2 Size options
ITEM NAME OF PARTS Q'TY
PLASTIC GRILLE 1
VERTICAL INSULATION STRIP 1
@ AROUND INSULATION STRIPS 2
C4) HORIZONTAL INSULATION STRIP 1
SUPPORT BLOCK 2
(B) BAFFLE 1
(?) TRIM FRAME 2
SHIM 2
PLASTIC NUTS AND WASHER SCREWS4
10 GRILLE REAR 1
A CAUTION
To avoid risk of personal injury, property damage,
or product damage due to the weight of this
device and sharp edges that may be exposed;
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people
are needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
• Carefully inspect location where air conditioner
wiil be installed. Be sure it will support the weight
of the unit over an extended period of time.
• Handle air conditioner with care. Wear
protective gloves whenever lifting or carrying the
unit AVOID the sharp metal fins of front and
rear coiis.
• Make sure air conditioner does not fail during
instailation.
REQUIRED TOOLS:
> Tight Fitting gloves
> Standard screwdriver
' Phillips screwdriver
' Pliers
' Sharp knife
' 3/8~inch open end
wrench or adjustable
wrench
> 1/4-inch hex socket
and ratchet
' Tape measure
' Electric drill
>
1/4-inch drill bit