Kenmore 580.71056 - Manual (Page 5)

INSTALLATION
INSTALLATION REQUIREMENTS
INSTALLATION HARDWARE
Your air conditioner will install into standard double
hung windows with actual clear opening widths of
22 to 36 inches (558mm to 914mm) (FIG. 1).
Lower sash must open sufficiently to allow a clear
vertical opening of 14 inches (356mm). Side louvers
and the rear of the air conditioner must have clear
air space to allow enough airflow through the
condenser for heat removal. The rear of the unit
must be outdoors, not inside a building or garage.
ELECTRICAL SERVICE
Check your available electrical service. The power
supply available must be the same as that shown
on the unit nameplate (found on left side of cabinet).
All models are equipped with a 3-prong service plug
to provide proper service and safe positive
grounding. Do not change plug in any way. Do not
use an adapter piug.
not match your plug, pall a qualified electrician to
make the necessary corrections. SAVE CARTON
and this OWNER'S MANUAL for future reference.
The carton is the best way to store unit during
winter or when not in use.
ITEM A: 11EA
SHORT SCREW
ITEM C; 3EA
L BRACKET
ITEM E: 1EA
SASH SEAL
(Not adhesive backed)
ITEM B; 4EA
WOOD SCREW
ITEM D; 1EA
SEAL STRIP
(Adhesive backed)
ITEM F: 2EA
GUIDE PANEL
ITEM G; 1EA
DRAIN PIPE
A CAUTION
To avoid risk of personal injury, property damage,
or product damage due to the weight of this
device and sharp edges that may be exposed:
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people
are needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit,
• Carefully inspect location where air conditioner
will be installed. Be sure it will support the
weight of the unit over an extended period of
time.
• Handle air conditioner with care. Wear
protective gloves whenever lifting or carrying the
unit. AVOID the sharp metal fins of front and
rear coils.
'
• Make sure air conditioner does not fall during
installation.
REQUIRED TOOLS:
• Tight Fitting gloves • 3/8-inch open end
• Standard screwdriver
wrench or adjustable
wrench
• Phillips screwdriver
• 1/4-inch hex socket
• Pliers
and ratcher
• Sharp knife
■ Tape measure
• Carpenters level
■ Electric drill
* 1/4-inch drill bit