Kenmore 78122 - Manual (Page 7)

INSTALLATION
Select the position that will place the sill
supports near the outermost point on sill {FIG. 11).
Attach the sill supports to the cabinet track hole
closest to the selected position using TYPE A
screw (S).
fQ
Place the sill supports with the cabinet on the
window sill's selected position.
The cabinet should be installed with a very
slight tilt (about 1/2") downward toward the outside
(FIG. 12).
Adjust the bolts and the nuts of sill supports to level
the cabinet.
m Attach the cabinet to the window stool by
driving the TYPE B screws (§) through the front
angle into window stool.
IE) Pull the window sash down behind the upper
guide. Pull each side curtain fully to each sash
track.
fQ
Attach each side curtain to the window sash
using TYPE C screws Q). (FIG. 14)
I Attach the window locking bracket (J|) with
TYPE C screw (
2
). (FIG. 15}
fQ Slide the chassis into the cabinet. (FIG. 16)
CAUTION: For security purpose, reinstall screws at
cabinet's sides.
insert between the upper window sash and the
lower window sash. (FIG. 17)
fQ
The vent control handle must be straightened
before the decorative front is attached.
Pull down part ® to align with part ®.