Kenmore 580.71121 - Manual (Page 7)

INSTALLATION
Select the position that will place the sill
supports near the outermost point on sill (FIG. 10).
Attach the sill supports to the cabinet track hole
closest to the selected position using screw ITEM E,
Lower guide
FIG, 10
Place the sill supports with the cabinet on the
window sill's selected position.
KE
The cabinet should be installed with a very slight
tilt {about 1/4") downward toward the outside (FIG. 11).
Adjust the bolts and the nuts of sill supports to level
the cabinet.
ED Attach the cabinet to the inner sill by driving the
screws (ITEM F) through tine front lower guide into
^Sasti
Tfack
^—lowef Guide
ITEMF
ITEM B ^ FIG. 12
m Pull each side curtain fully to each side of
window opening. Attach each side curtain to the
window sash using screws (ITEM G). (FIG. 13)
m Attach the L bracket (ITEM J) with screw
(ITEM G). (FIG. 14)
Be sure to insert the drain pipe into base pan before
installation.
The air conditioner must be installed with a slight tilt
to the outside for proper water drainage.
The air conditioner will drain the excess condensed
water through the drain pipe. (FIG. 15)
DRAINPIPE
-BASE PAN REAR
tZ^ZZZZZZZZZZZZ2i
BASE PAN BOTTOM
FIG. 15
CIH
iCi Slide the air conditioner into the cabinet. (FIG. 16)
CAUTION; For security purposes, reinstall side screws
you removed in step 1.
Cut the foam seal (ITEM H) to the proper
length and insert between the upper window sash
and the lower window sash. (FIG. 17)
ITEM H
FIG. 17
iB
The vent control handle must be straightened
before the decorative front is attached.
- 7