Kenmore 580.5145 - Manual (Page 6)

OPERATION
-;«£High
HUMIDITY
CONTROL
»¿Constant
B H i .
>4 Hr.
• 2 Hr.
CONTROL PANEL
Your dehumidifier control panel contains a Bucket Full indicator, a Humidity indicator, a Power
Control, Humidity Control, Fan Speed Control and Timer Control.
Bucket Full indicator —This light glows when the water bucket is full and needs to be emptied.
Power — Operation starts when this button is pressed and stops when the button is pressed again.
Humidity Control — This controls the humidity in the room.
• To raise the humidity setting
•To lower the humidity setting
• The humidity can be set within a range of 30% RH-70% RH by 5% increments.
Fan Speed — This controls the speed of the airflow.
* High; Fan speed is set to high.
* Low; Fan speed is set to low.
* When Fan Speed button is pressed, the fan speed mode is changed.
Timer Control — Press the Timer button to set the amount of time you want the unit to run.
• The Timer can be set for; Constant, 8 hour, 4 hour or 2 hour.
• When Timer button is pressed, the Timer indicator lights shift as follows;
Constant -> 2 hr. 4 hr. 8 hr. Constant
TO OPERATE THE DEHUMIDIFIER:
1. Plug the power cord into an electrical outlet. Press the power button.
2. Set the Humidity Control anywhere between 30% RH and 70% RH for normal operation.
If you need drier air, press the Humidity Control button.
If you need less moister air, press the Humidity Control button.
3. Press the Power button to stop the unit manually.
4. Press the Timer button to set the amount of time you want the unit to run.
At the end of that time, the unit will shut off.
The Timer can be set for; Constant, 8 hours, 4 hours or 2 hours. .
5. If you want to control the speed of airflow, press Fan Speed button. Each time that the Fan Speed button
is pressed, the fan speed mode is shifted; High Low High
Note; Be careful not to lose the water bucket.
This dehumidifier doesn't run if the water bucket is not installed properly.
6 -