Kenmore 580.75051 - Manual (Page 10)

OPERATION
DISPLAY
REMOTE CONTROL SIGNAL RECEIVER
TEMPERATURE SETTING
• Use this button to automatically control the temperature
of the room. The temperature can be set within a range of
60°F to 86“F by increments of 1°F.
ENERGY SAVER
■ The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on and
check the room air to determine if cooling is needed.
DISPLAY COOL/FAN
• Everytime you push this button, it will toggle between
COOL and FAN.
ON/OFF TIMER
SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running, Timer sets number of hours until shut-off.
• For your sleeping comfort, once Timer is set, the Temperature
setting will raise 2°F after 30 min., and once again after another
30 min.
• Every time you push Timer button, it advances the Timer setting
as follows: 1 Hour ► 2 Hours ► etc. ► 12 Hours maximum.
START TIME
• If unit is off, Timer sets number of hours before unit starts.
• Every time you push Timer button, it advances the Timer setting
as follows: 1 Hour ► 2 Hours ► etc. ► 12 Hours maximum.
POWER
• To turn the air conditioner ON, push the button. To turn the air
conditioner OFF, push the button again.
• This button takes priority over any other button.
• When you first turn it on, the unit is in cool mode, High fan
speed, Temperature setting at 72°F.
FAN SPEED
• Everytime you push this button, it advances the setting as
follows: {High(F2) ► Low(FI) ► High(F2)}
In failure of electric power, the unit runs as previous setting operation.
10