Filter change schedule, Filter replacement – Kenmore HEPA 152.85254 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION coni.
•TURBO
•HI
•MED
•LO
Initial Operation
Maximum Operation
Daytime Operation
Nighttime Operation
Fastest Cleaning
Fast Cleaning
Normal Cleaning
Quieter Operation
FILTER CHANGE SCHEDULE
' Pre-Filter: The pre-filter should be changed every three (3)
months or sooner, depending upon the level of the room's
air contaminants and the frequency of use.
’ HERA Filter; The usable lifetime of the HEPA filter is
1 - 3 years, depending upon the level of the room's
air contaminants and the frequency of use. The air volume
output will begin to decrease dramatically when the filter
needs to be changed. You should have a spare filter
available for later replacement.
FILTER REPLACEMENT
These filters are specially designed for easy replacement at maximum
performance.
THE FILTERS ARE NOT WASHABLE.
1. Turn the air cleaner OFF and unplug it from the power outlet.
2. Carefully lay the unit down on a flat surface with the Front
Grille facing up.
3. Gently push in on Release Buttons on both sides of the unit
and swing out the Front Grille.
4. Pre-Filter
• The pre-filter is attached to the HEPA filter frame with
six adhesive pads. Detach pre-filter and discard it.
• Remove and discard any plastic protective wrapping
from the new pre-filter.
• Lay pre-filter on HEPA filter and gently push it against
adhesive pads to attach it to the HEPA frame.
5. HEPA Filter
• Remove and discard any plastic protective wrapping
and packaging from the new HEPA filter.
• Attach a new pre-filter to the new HEPA filter frame see
Pre-Filter attachment instructions above).
Note; Always Install
new
pre-filter when changing
HEPA filter.
• Place the filter assembly into the unit.
6. Install the Front Grille by engaging its tabs into the bottom
slots on the unit. Then swing grille up and gently push in top
to snap into place.