GE 1-Jul - Manual (Page 5)

Wake
10*00
ILILIU
NAP
Setting the WAKE Time
Your digital clock operates on a 12 hour
standard mechanism,
1, Press the SET button untii WAKE 1 /
WAKE 2 icon is biinking.
2, Press REV C] or FWD ta to set the wake
time. The time decrements or increments
wiil foliow by a faster rate when you press
and hold either REV c3 or FWD Ca.
3, After the WAKE time is set, press SET
repeatediy until no icon is blinking.
Tip;
The unit equips with SflAb-U-WAKE
feature, the donn tone volume will increose
gradually to its maximum in about 30 to 45
seconds.
Tip:
If you set the SLEEP function with low
volume level before going to bed, we advise
using WAKE mode to wake you up since
its volume will automatically increase.
Waking by Selected Source
You may be woken up by WAKE "i, RADIO
d or CD
1. Select an AM or FM station.
2. Set wake time (see above directions).
3. Press WAKE 2 or WAKE 1 to select wak­
ing up by WAKE it, radio d or CD 0,
Corresponding indicator will be up next
to the selected setting.
4. Adjust the volume by turning VOLUME.
You can select your CD wake track by the
following procedures.
1. Press WAKE UP CD TRACK.
2. While pressing, press REV crlJ or FWD
Ca to select your desired CD wake up track.
Mote;
When you turn off the alarm by pressing
OFF, the alarm will turn on at the Some
time tomorrow.
ODeratinq the Clock Radio
Sleep Mode
In sleep mode, the radio or CD will turn
off automatically. Simply:
1. Listen to CD or radio.
2. While holding SLEEP, press REV C] or
FWD ta to set the sleep time. The time
range is from 1 minute to 2 hours.
3. Release SLEEP and the current time will
be shown again. The radio or CD will turn
off when the preset time elapses. If you
decide to turn off the radio or CD sooner,
press SNOOZE or OFF.
4. When SLEEP is activated again, the sleep
time will be the same as the one you have
set before,
5. Press SLEEP to read the remaining sleep
time.
Nap Mode
This function wakes you up after a short
period of time. Simply:
1. Press NAP and release. The NAP indica­
tor will flash. During this period, adjust
NAP time by pressing REV dor FWD CSt.
The range is from 10 minutes to 2 hours.
2. The clock will be shown after 5 seconds
if no button is pressed. The
nap indicator
will lit up.
3. Press NAP once to show time left.
Stop the Nap alarm
Press NAP or follow "Turning off Alarm".
1. Press and hold NAP to cancel the nap
setting,
2. Only alarm sound can be selected.
3. Nap alarm is equipped with GRAD-U-
WAKE feature.
Turning off Alarm
Silence the alarm momentarily
Press SNOOZE. The alarm will sound again
when the snooze period is over, (See
"Snooze Alarm Operation").
Stop the alarm
Press OFF. The alarm will sound on the
following day at the same time.
Disable the alarm permanently
1. Press CANCEL.
2. The WAKE indicator will be flashing.
3. Press WAKE 1 or WAKE 2 within 3
seconds to deactivate the corresponding
alarm function permanently.
Tip:
You can activate the previously set alarm
time by pressing
WAKE 1 or WAKE 2