Using the dehumidifier, Removing collected water, Installing the water bucket – GE AHG50LH User Manual
Page 6: Water level, Water i.evel
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
.i
I
<&•
to
Using the dehumidifier.
Always make sure the water bucket Is locked into place on the dehumidifler.
I
ts
(C
CO
Removing Collected Water
There are 3 ways to remove collected water:
7
Use the bucket
When the bucket is l emoved,
the unitwill shut off. Empty and replace the
bucket.
Use a floor drain.
The unit can also be placed
over a floor drain. Using a drill, make a hole
at the end of the nozzle located on the lowei’
left side of the bucket.
Use a hose.
Water can be automatically
emptied into a floor drain by atfciching a
watei’ hose (not included) to the bucket hose
nozzle. Using a drill, make a hole at the end
of the nozzle located on the lower left side of
the bucket. Attach a water hose to the bucket
nozzle. Fasten bv hand onlv.
Attach hose:
NOTE:
The nozzle cannot be fixed after puncture. Use
an ordinary garden hose cap (not included) to reclose
if necessary.
NOTE:
Avoid using mechanical tools to tighten the
water hose to the bucket nozzle. This may damage the
threads on the nozzle.
Installing the Water Bucket
lift the bucket and hook the slots on each side
onto the posts on the back of the dehumidifier.
The bucket should lock securely in place.
Make sure the bucket is locked securely in place
by pressing down on the uppei’ back edge of the
bucket. It will be fimily seated when projrerly
installed.
6
Water Level
The dehumidifier will turn off automatically
wiien the bucket is full, or when the bucket is
removed or not replaced in the propei’ position.
The bucket must be replaced in the proper position for
the dehumidifier to work. The light will be on and the
dehumidifier will not run if the bucket is notin the
proper position.