beautypg.com

Setting the dmx starting address, Legend™ 550 troubleshooting, Technical support – Chauvet LEGEND 550 User Manual

Page 23

background image

Legend™ 550 Spot User Manual

23

1/11/2010 11:36 AM

Setting the DMX starting address

This DMX mode enables the use of a universal DMX controller device. Each fixture requires a "start address"

from 1 ~ 512. A fixture requiring one or more channels for control begins to read the data on the channel

indicated by the start address. For example, a fixture that uses 6 DMX channels and was addressed to start on

DMX channel 100, would read data from channels: 100, 101, 102, 103, 104, and 105. Choose start addresses

so that the channels used do not overlap, and note the start address selected for future reference.

If this is your first time addressing a fixture using the DMX control protocol, we suggest jumping to the

“Appendix” section and reading the heading “DMX Primer”. It contains very useful information that will help you

understand its use.


Legend™ 550 Troubleshooting

Symptom

Solution(s)

Auto shut off

Check fan thermal switch reset

Beam is very dim or not bright

Clean optical system or replace lamp
Check voltage switch for proper setting

Breaker/Fuse keeps blowing

Check total load placed on device

Device has no power

Check for power on Mains.
Check device’s fuse. (internal and/or external)

Fixture is not responding

Check Display settings for correct addressing
Check DMX cables

Lamps cuts off sporadically

Possible bad lamp or fixture is overheating.
Lamp may be at end of its life.

Light will not come on after power
failure

Discharge lamps require a cooling off period before the electronics in the
fixture can kick start it again, wait 5 ~ 10 minutes before powering up.

Loss of signal

Use only DMX cables
Install terminator
Note: Keep DMX cables separated from power cables or black lights.

Moves slowly

Check FasTap™

No light output

Check lamp

Stand alone mode

This fixture features stand-alone functions. See “Menu Map” for details.

If you still have a problem after trying the above solutions, please contact CHAUVET Technical
Support at the location listed below.

Technical Support


Address: Service Dept.
3000 N 29th Ct, Hollywood, FL 33020 (U.S.A.)
Support (Email): [email protected]
Telephone: (954) 929-1115 - (Press 4)
Fax: (954) 929-5560 - (Attention: Service)
Website: http://www.chauvetlighting.com