Harbor Freight Tools ITEM 92037 - Manual (Page 10)

Page 10 For technical questions, please call 1-800-444-3353. Item 92037
Operating instructions
Read the entiRe imPORtant SaFetY inFORmatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
inspect tool before use, looking for damaged, loose, and missing parts.
if any problems are found, do not use tool until repaired.
tool Set up
tO PRevent SeRiOuS injuRY FROm aCCiDental OPeRatiOn:
turn off the tool, detach the air supply, safely discharge any residual air pressure in the tool, and
release the trigger before performing any inspection, maintenance, or cleaning procedures.
tO PRevent SeRiOuS injuRY:
Do not adjust or tamper with any control or component in a way not specifically explained within this manual.
improper adjustment can result in tool failure or other serious hazards.
Installed Chisel
Retainer Spring Chisel Cylinder
Figure D
1. Unscrew the Retainer Spring from the Cylinder.
2. Insert the 10 mm Chisel shank into the Cylinder.
3. Screw in the Retainer Spring completely
onto the threads of the Cylinder until it stops,
to solidly hold the Chisel in place.
4. Pull firmly on the Chisel to make
sure it is secured in place.
Workpiece and Work area Set up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the air hose along a safe route to reach
the work area without creating a tripping hazard
or exposing the air hose to possible damage.
The air hose must be long enough to reach
the work area with enough extra length to
allow free movement while working.
3. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be hazardous objects
(such as utility lines or foreign objects) nearby
that will present a hazard while working.
Sa
Fet
Y
O
Pe
R
ati
O
n
m
aintenan
C
e
Setu
P