Whirlpool EB19MK - Manual (Page 7)

Moving the meat pan...
The meat pan can be taken out and moved the
same way as the shelves. Remove the meat pan first
Removing:
Slide the meat pan out to stop
LItt the front of meat pan
Slide pan the rest of the way out.
Tit cover up at front
Lift up at back
Pull straight out
Replacing:
1, Guide the rear hooks into the slots in the shelf
supports
Tilt up front of cover until rear hooks drop into slots.
Lower front of cover to level position
Replace meat pan in reverse order.
2
3
Changing the light hulbs...
rfefore removing the light shield for cleaning or for
ep ac ng tne bu b unplug the refrigerator, use
roD/'once ijuibs >nly
Push in the Center;
Pull Down,
Refrigerator light:
• Pus,n lightiv on me top center of the lignt shield unti
the notcned tob unhooks from the control pane
• Pull dov.'T' or me shield untt the tab clears the
control panel
• Lift me back hrjoks out of their slots
• Reoidce with a 40-watt appliance buib
• Replace light snield in reverse order
Freezer light:
• The freezer light shield pulls straight out from the
freezer wall. Replace In reverse order.
Removing the base grille...
• Open me doc'
Pull grille outwards as shown
Do not remove Tech sheet fastened behind grille
Metal Clips
Support Tabs
To replace:
• Line up grille si ipport tabs with metal clips
• Push firmly to S'‘iap into oldce
• Close the doc-
Ice cube trays...
To remove ice:
• Hold tray at both ends,
• Slightly twist
If cubes are not used, they may shrink. The moving
cold air starts a slow evaporation. The longer cubes
are stored, the smaller they get.
Optional automatic ice maker...
On
If you have the automatic ice maker accessory or
plan to add one later [Part No, ECKMF-6), there are
a few things you will want to know
• The ON OFF lever is a wire signal arm
Down,,,for making Ice automatically;
Up,,,to shut off the Ice maker,
• Shake the bin occasionally to keep cubes sepa­
rated, and to obtain increased storage capacity,
• It is normal for ice crescents to be attached by a
corner. They will break apart easily,
• You will hear water running when ice maker is
working. You'll hear Ice fall into the bin. Don't let
these scxinds bother you
• The ice maker will not operate until the freezer is
cold enough to make ice. This can take overnight,
• Because of new plumbing connections, the first
ice may be discolored or off-flavored. Discard the
first few batches of ice
• If ice IS not being made fast enough and more ice
is needed, turn the Temperature Control toward a
higher number. Wait a day and, if necessary, turn
the Air Control toward A,
• If you remove the ice bin, raise the signal arm to
shut off the ice maker. When you return the bin,
push it all the way in and lower the arm to the ON
position
• If cubes are stored too long, they may develop an
off-flavor,,,like stale water. Throw them away. They
will be replaced. Cubes in the ice bin can also
become smaller by evaporation