beautypg.com

Jump-starting procedure – Chrysler 2007 Town and Country User Manual

Page 401

background image

• For convenience in checking the spare tire inflation,

stow with the valve stem toward the rear of the
vehicle.

• Using the jack handle, rotate the drive nut to the

right until the wheel is drawn into place against the
underside of the vehicle.

• Continue to rotate the nut until you hear the mecha-

nism click three times. It cannot be overtightened.
Push against the tire several times to be sure it is
securely in place.

13. Stow the jack and jack handle.

14. Check the tire pressure as soon as possible. Correct
pressure as required.

JUMP-STARTING PROCEDURE

WARNING!

Do not attempt to push or tow your vehicle to get it started. Vehicles
equipped with an automatic transmission cannot be started this
way. Unburned fuel could enter the catalytic converter and once the
engine has started, ignite and damage the converter and vehicle. If
the vehicle has a discharged battery, booster cables may be used to
obtain a start from another vehicle. This type of start can be
dangerous if done improperly, so follow this procedure carefully.

Battery fluid is a corrosive acid solution; do not allow battery fluid
to contact eyes, skin or clothing. Don’t lean over battery when
attaching clamps or allow the clamps to touch each other. If acid
splashes in eyes or on skin, flush contaminated area immediately
with large quantities of water.

A battery generates hydrogen gas which is flammable and explo-
sive. Keep flame or spark away from the vent holes. Do not use a
booster battery or any other booster source with an output that
exceeds 12 volts.

Take care to avoid the radiator cooling fan whenever the hood is
raised. It can start anytime the ignition switch is on. You can be hurt
by the fan.

WHAT TO DO IN EMERGENCIES

401

6

This manual is related to the following products: