Clarion APX401.4 - Manual (Page 15)

Owner’s Manual
15
Problem
Amplifier fuse keeps blowing.
Solution
Incorrect wiring or short circuit. Review Installation and check all wiring connections.
Problem
Whining or ticking noise in the audio with engine on.
Solution
Amplifier is picking up alternator noise or radiated noise. Turn down input gain;
move audio cables away from power wires. Check power and ground connections
on amplifier; install an in-line noise filter on source unit’s power wire; check
alternator and/or voltage regulator; test for weak battery or add water to battery.
Frequency Response
Signal Noise Ratio
THD
Input Sensitivity Low Level
Input Sensitivity Speaker Level
Max. Power Output
Cont. Power Output
2-Ohm Stereo Output
Bridged Power
Dimensions
Current Consumption @ Max
Power Output 20Hz ~ 20kHz
>95db
.05% all channels driven
250mV ~ 2.5V
500mV ~ 5V
380w (190 x 2)
200w (50w x4) @.08% THD
90 x 4 @ .8% THD
190 x 2 @ .8% THD
2 1/8” H x 8 1/4” W x 12” L
46A @ 380 Watts
PRODUCT SPECS
APX401.4.qxd 12/5/01 12:58 PM Page 15