Whirlpool ED20PK - Manual (Page 4)

Before using your
refrigerator
1 Remove sales labels...
Remove the Consumer Buy Guide Label, tape
and any inside labels before using the refrigera­
tor. To remove any remaining giue:
1. Rub briskly with thumb to make a ball then
remove.
OR
2. Soak area with liquid hand dishwashing de­
tergent before removing glue as described in
step 1.
DO NOT USE Sharp instruments, rubbing alco-
hoi, fiammabie fiuids or abrasive cieaners.
These can damage the materiai. See “impor­
tant Satety Instructions” on page 3.
NOTE: DO NOT REMOVE ANY PERMANENT IN­
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigeratcr at the front.
2. Clean it...
Clean your refrigerator before using it. See
cleaning instructions on page 9.
4. Install properly...
3. Plug it in...
3-PRONG GROUNDING
TYPE WALL RECEPTACLE
REFRIGERATOR
POWER CORD 3-PRONG
GROUNDING PLUG
RECOMMENDED GROUNDING METHOD
A115 Volt. 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re­
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Do not use an extension cord. Use a recepta-
cie which cannot be turned off with a switch or
puli chain. See Electrical Requirements and
Grounding Instruction Sheet in your Literature
Package.
1. Allow V 2 inch (1.25 cm) space on each side and
at the top of the refrigerator for ease of
installation.
2. If the refrigerator is to be against a wall, you
might want to leave extra space on the hinge
side closest to the wall so the door can be
opened wider.
3. The refrigerator back can be flush against the
wall.
5. Level refrigerator-freezer...
I
USE SCREWDRIVER
TO ADJUST
FRONT ROLLER
LEVELING SCREW
RAISE
1
. Remove base grille. (See page 8.)
2. To raise front, turn screw in direction shown.
3. To lower front, turn screw in direction shown.
4. Check with level.
5. Replace base grille. (See page 8.)