Whirlpool Blue Creek JRSD209A - Manual (Page 12)

Removing and Replacing the Automatic Ice Cube
Dispenser Bin
Lift the front of the Automatic Dispenser bin and pull it straight out. Wash the bin
occasionally in mild soap and lukewarm water. To replace the bin, push it all the way
back until the bottom of the bin is behind the raised edge at the front of the shelf it rests
upon. Make sure the tabs, at the back of the bin, that turn the spiral augerare positioned
between the prongs from the auger motor.
Operating Your Automatic Ice and Water Dispenser
Water/lce Control
For dispensing ice cubes, the slide control must be
moved to the "Cube" position (center). For dispensing
crushed ice, move the control to the "Crushed" position
(left).
For dispensing chilled water, the slide control must be
moved completely to the "Water" position (right).
Water from the dispenser is chilled. For colder water
simply add ice before dispensing the water. Also, the
first glass of water dispensed each time may be warmer
than consecutive glasses. It will be cooler if a full glass
of water is dispensed rather than a partial glass. Fill a
container with ice before adding liquid to prevent splash­
ing.
Dispensing
To fill a glass, position the glass against the top portion
of the actuator pad and press.
Hold the g lass high I n the
dispenser opening to reduce the ice falling outside
the glass.
Some crushed ice may be dispensed even though you
selected CUBE. This happensoccasionally when afew
cubes accidentally get channeled in the crusher.
When changing from crushed ice to cubes, some crushed
ice may be dispensed. This may also happen if irregular
sized cubes or ice chips are in the storage bin.
There maybe a delay when you switch from cubes to crushed ice. It takes afew seconds
for the cubes to be channeled in the crusher. Crushed ice pieces will vary in size and
shape.
12