Before using your refrigerator, Removing packaging materials, Cleaning it before use – Whirlpool 4ED25DQ User Manual
Page 5: Cleaning it, Plugging it in
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BEFORE USING YOUR REFRIGERATOR
Before Using Your
Refrigerator
In This Section
Page
Cleaning it...............................
Page
................ 5
Installing it properly...............
................ 6
Plugging it in...........................
................ 5
Leveling it................................
................ 6
It is important to prepare your refrigerator for use. This section will tell you how to clean it,
connect it to a power source, install it and level it.
Cleaning it
Removing packaging materials
Remove tape and any inside labels (except
the model and serial number label) before
using the refrigerator.
To remove any remaining glue:
• Rub briskly with thumb to make a ball, then
remove.
OR
• Soak area with liquid hand-dishwashing
detergent before removing glue as de
scribed above. Do not use chart instru
ments, rubbing alcohol, flammable fluids or
abrasive cleaners. These can damage the
material. See “Important Safety Instruc
tions” on page 3.
Plugging it in
Recommended Grounding Method
A 220 Volt, 60 Hz., AC only 15 or 20 ampere
fused and properly grounded electrical
supply is required. It is recommended that a
separate circuit serving only this appliance
be provided. Use a receptacle which cannot
be turned off with a switch or pull chain. Do
not use an extension cord.
NOTE:
Do not remove any permanent
instruction iabels inside your refrigerator. Do
not remove the Tech Sheet fastened under
the refrigerator at the front.
Cleaning it before use
After removing all packaging materials,
clean your refrigerator before using it, if
necessary. See cleaning instructions on
pages 18 and 19.