Whirlpool 1ADM202XX0 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Caring For Your Dehumidifier

Continued

Remove the rear grille. Push top of grille

down. When tabs release from cabinet,

rotate grille toward you. Detach bottom of
grille from cabinet mounting pins.
Lift cabinet from base.

Tabs—

Filter

3. Remove filter from back of rear grille:

• Gently pull top of filter toward you until

tabs release from grille.

• Pull filter up and away from grille.

4. Clean filter with a vacuum cleaner or, if very

dirty, wash with warm water and mild deter
gent. Air dry thoroughly before replacing.

Coils should be inspected annually. Brush
clean, if necessary, with warm water and mild
detergent. Rinse and dry thoroughly. Be sure
power supply cord is disconnected from
receptacle.
The compressor is sealed and needs no
oiling. The fan motor Is prelubricated and
does not require further oiling under
normal operating conditions. However, if

the dehumidifier is operated under severe
environmental conditions (dust, dirt, high
temperatures) the fan motor should be oiled
annually. Follow the instructions in step 5.

Coils

10.

Oil the motor through the tubes provided. Use
SAE #20 grade oil.
Wash plastic parts with a soft cloth, warm

water and mild detergent. Rinse and dry with
a soft cloth.

Replace cabinet, filter and grilles.
Reconnect power supply cord.