Whirlpool SF317PEY - Manual (Page 18)

C A R I N G F O R Y O U R R A N G E
Gas must flow freely through the small hole in the
brass orífice for the burner to light properly. This
area must be free of any soil and be kept
protected from boilovers or spillovers. ALWAYS
keep the burner caps in place whenever a
surface burner is in use.
After cleaning the gas tube opening, repiace
the burner cap and burner pan.
Occasionaily check the burner flames for
proper size and shape as shown. A good flame is
blue in color. If flames lift off ports, are yellow, or
are noisy when turned off, you may need to clean
the burners. If ports are clogged, clean with a
straight pin. Do not enlarge or distort port. Do not
use a wooden toothpick. If adjustment is
needed, call a qualified technician for service.
To replace burner cap, make sure cap is
properly aligned and leveled. Find the recessed
locating tabs on the burner cap (see illustration)
and place cap over the white ignitor in the burner
base.
Turn the burner on to determine if it will light. If
the burner does not light after cleaning,
contact
an authorized Whirlpool^** service
technician. Do not service the sealed burner
yourself.
_____________________
''^^^TnTFlluouyupTit^
I ' —.=1
Typical surface burner flame
Locating tabs
Removing the oven door
Removing the oven door will help make it easier
to clean the oven.
^WARNING
Burn and Electrical Shock Hazard
Make sure all controls are OFF and the oven is
cool before removing oven door. Failure to do
so can result in burns or electrical shock.
To remove:
1. Open the door as far as it will go.
2. Remove the screws on each side of the oven
door.
3. Close the door about of the way.
4. Lift the door up and off the hinges.
Screw
18