Whirlpool DH25G0 - Manual (Page 3)

□
Installing dehumidtfier
Good air circulation is
needed for best
performance—allow at
least 12-18 inches (30.5 -
45.7 cm) of air space on all
sides of the dehumidifier.
Keep all outside doors,
windows and other
openings closed when
operating dehumidifier.
Humid outdoor air will
increase dehumidifier
work load.
12-18"
(30.5 - 45.7 cm)
12-18"
(305-45.7 cm)
Install dehumidifier on a level floor strong enough to support
the dehumidifier with a full bucket of water.
65°
(18.3°C)
Install your dehumidifier in an area
where the temperature will not fall
below 65°F (18.3°C). Lower temper­
atures will cause ice to form on coils.
65°-
(18.3°C)
«
When moving dehumidifier, use the grip
areas with both hands to push
dehumidifier to a new location. Do not
lift the dehumidifier with grip area. Pick
dehumidifier up from the bottom to
carry.
If icing occurs, unplug dehumidifier (or
turn off) until ice melts and room
temperature rises.
Operating dehumidifier
EMPIY/ADJUST BUCKET light DRYNESS CONTROL:
If this light is on, the dehumidifier is
not running. This light indicates that
you need to check:
• If the bucket is full, empty bucket
and replace.
• If the bucket is not in position,
remove bucket and replace. Make
sure the bucket fits all the way into
the dehumidifier and the light is off
or dehumidifier will not run.
This controls the amount of moisture in
the room.Turn the control knob
clockwise for more drying.Turn the
control knob counterclockwise for less
drying.Turn control knob to "NORMAL"
to maintain average humidity
conditions.
NOTE: For the first few days of use, turn
the Dryness Control clockwise to
"DRYEST"to remove extra moisture
Some models: this controls fan
operation. Use desired setting.
HIGH - for faster moisture removal.
LOW - for slower moisture removal.