Exterior moisture control, Adjusting the refrigerator shelves, To remove the shelves – Whirlpool ED20SK User Manual
Page 6: Removing the crisper, crisper cover and trivet, To remove the trivet, Air circulation control
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using Your Refrigerator
Continued
EXTERIOR
MOISTURE
CONTROL
OFF
ON
Exterior moisture control
The Exterior Moisture Control on the Control
Console operates electric heaters around the door
openings. These heaters help keep moisture from
forming on the outside of the refrigerator.
1 ■ Use the OFF setting when humidity is low.
2. Use the ON setting if moisture forms on the
outside of the refrigerator.
Adjusting the refrigerator shelves
Shelves can be adjusted to match the way you use
your refrigerator.
To remove the shelves:
1. Tilt up at front.
2. Lift up at back.
3. Pull shelf straight out.
To replace the shelves:
1. Guide the rear hooks into the slots in the shelf
supports.
2. Tilt up at front of shelf until hooks drop into slots.
Lower front of shelf to level position.
' Removing the crisper, crisper cover
and trivet
To remove the crisper:
1. Slide straight out to the stop.
2. Lift the front, then slide out the rest of the way.
3. Replace in reverse order.
To remove the crisper cover:
1. Tilt up at front.
2. Lift up at back.
3. Pull cover straight out.
To replace the crisper cover:
1. Guide the rear hooks into the slots in the
shelf supports.
2. Tilt up at front of shelf until hooks drop
into slots.
3. Lower front of shelf to level position.
To remove the trivet:
The trivet can be removed for easier cleaning.
1. Slide trivet straight out.
2. Replace trivet with higher edge toward rear of
refrigerator.
Air circulation control
The air circulation control allows air to move be
tween the freezer and the refrigerator. If moisture
collects below the trivet, open the control slightly.
NOTE: If food near air circulation control begins to
freeze, close control.