Removing the base grille, Changing the light bulbs, Electrical shock hazard – Whirlpool 3ET16NK User Manual
Page 14: To change refrigerator light, Removing the base grille changing the light bulbs, Awarning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Removing the base grille
To remove the base grille:
1. Open the refrigerator door.
2. Grasp the grille with both hands.
3. Push down on the top edge of the grille to
release the top clips.
4. Roll grille toward you to release top clips.
5. Pull grille away from the refrigerator.
NOTE: Do not remove the Tech Sheet
fastened behind the grille.
To replace the base grille:
1. Line up the edges of the grille with the
outside edges of the cabinet.
2. Roll the grille toward you.
3. Place the lower clips in the openings in
the metal panel.
4. Roll the grille toward the cabinet until the
top clips snap into place.
5. Close the refrigerator door.
See cleaning instructions for defrost pan and
condenser coils on page 16.
Condenser
Defrost
coils
pan
Clips
Changing the light bulbs
AWARNING
Electrical Shock Hazard
Before removing a light bulb or removing
a light shield for cleaning, either unplug
the refrigerator or disconnect the electric
ity leading to it at the main power supply.
Failure to do so could result in electrical
shock.
To change refrigerator light:
1. Disconnect refrigerator from power
supply.
2. Reach behind Control Panel to remove
bulb.
3. Replace with a 40-watt appliance bulb.
4. Reconnect refrigerator to power supply.
NOTE: Not all appliance bulbs will fit your
refrigerator. Be sure to replace a bulb with
one of the same size and shape.