beautypg.com

Installing dehumidifier, 3°c), 65°- (18.3°c) – Whirlpool Dehumidifier User Manual

Page 3: Operating dehumidifier, Empty/adjust bucket light: dryness control

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Installing dehumidifier

Good air circulation is needed
for best performance—allow
at least 12-18 inches (30.5 -
45.7 cm) of air space on a
sides of the dehumidifier.

Keep all outside doors,
windows and other
openings closed when
operating dehumidifier.
Humid outdoor air will
increase dehumidifier
workload.

12-18"

(30.5 - 45.7 cm).

12-18"

(30i-45.7cffl)

Install dehumidifier on a level floor strong enough to support the
dehumidifier with a full bucket of water.

65°

(18.3°C)

Install your dehumidifier in an area
where the temperature will not fall
below 65°F (18.3°C). Lower temper­
atures will cause ice to form on coils.

65°-

(18.3°C)

When moving dehumidifier, use the grip
areas with both hands to push
dehumidifier to a new location. Do not

lift the dehumidifier with grip area. Pick
dehumidifier up from the bottom to
carry.

If ice forms on coils, some dehumidifiers

will continue to cycle on and off. Some
dehumidifiers have a de-icer feature that
will automatically shut the dehumidifier
off when ice forms. Unplug either type of
dehumidifier until ice melts and room
temperature rises.

Operating dehumidifier

EMPTY/ADJUST BUCKET light:

DRYNESS CONTROL:

If this light is on, the dehumidifier

is

not running.

This light indicates that

you need to check;

* If the bucket is full,

empty bucket

and replace.

* If the bucket is not in position,

remove bucket and replace. Make
sure the bucket fits all the way into

the dehumidifier and the light is off,
or dehumidifier will not run.

This controls the amount of moisture in
the room.Turn the control knob
clockwise for more drying.Turn the
control knob counterclockwise for less
drying.Turn control knob to "NORMAL"
to maintain average humidity
conditions.

NOTE:

For the first few days of use, turn

the Dryness Control clockwise to
"DRYEST"to remove extra moisture

Some models: this controls fan
operation. Use desired setting.

HIGH

- for faster moisture removal.

LOW

- for slower moisture removal.