CHEVROLET 2011 Equinox - Manual (Page 317)

Black plate (31,1) Chevrolet Equinox Owner Manual - 2011
Vehicle Care 10-31
Headlamp Aiming
The headlamp aiming system has
been preset at the factory.
If the vehicle is damaged in an
accident, the aim of the headlamps
may be affected and adjustment
may be necessary.
It is recommended that a dealer
adjust the headlamps. To re-aim
the headlamps yourself, use the
following procedure.
The vehicle should be properly
prepared as follows. The vehicle:
. Should be placed so the
headlamps are 7.6 m (25 ft)
from a light colored wall.
. Must have all four tires on a
level surface which is level all
the way to the wall.
. Should be placed so it is
perpendicular to the wall or
other flat surface.
. Should not have any snow, ice,
or mud on it.
. Should be fully assembled and
all other work stopped while
headlamp aiming is being
performed.
. Should be normally loaded with
a full tank of fuel and one person
or 75 kg (160 lbs) sitting on the
driver's seat.
. Tires should be properly inflated.
Headlamp aiming is done with the
vehicle's low-beam headlamps.
The high-beam headlamps will be
correctly aimed if the low-beam
headlamps are aimed properly.
To adjust the vertical aim, do the
following:
1. Open the hood. See Hood on
page 10‑5 for more information.
2. Locate the aim dot on the lens of
the low‐beam headlamp.
3. Measure the distance from the
ground to the aim dot on the
low‐beam headlamp. Record the
distance.