Champion Power Equipment 12090 - Manual (Page 15)

REV 12090-20140108
12
12090 ENGLISH
MaInTenanCe
The owner/operator is responsible for all periodic
maintenance .
lubrication
All moving parts within the Utility winch having
been Lubricated using high temperature lithium
grease at the factory . No internal lubrication is
required . Lubricate cable assembly periodically
using a light penetrating oil .
Cleaning
Use a damp cloth to clean the exterior surfaces
of the winch . Use a soft bristle brush to remove
excess dirt and oil . Use an air compressor
(25 PSI) to clear dirt and small debris from the
wire cable spool and other tight places .
Cable assembly Replacement
It is recommended that any wire cable or spool
modifications be performed by a manufacturer’s
authorized repair facility, and that only
manufacturer-supplied parts be used .
storage
It is recommended the utility winch is stored
indoors, in a clean dry place, free from sunlight
and moisture .
1 . Make sure the winch is properly cleaned
before storage .
2 . Make sure the wire rope is drawn onto the
spool as much as it can be without damage .
3 . Make sure to tie up all cords .
4 . Store in a place that moisture can not
damage the winch .
5 . Store in place that excess dust or debris can
not damage the winch .
Complete all scheduled maintenance in a timely
manner . Correct any issue before operating the
winch .
Never operate a damaged or defective winch .
WaRnInG
Improper maintenance will void your warranty .
WaRnInG
For service or parts assistance, contact our
help line at
1-877-338-0999
noTe
DO NOT spray water directly on the winch or
wire cable . DO NOT wipe the wire cable with
the damp cloth . Use only compressed air to
clean the wire cable .
CaUTIon