beautypg.com

Operation, Log splitter operation – Champion Power Equipment 92500 User Manual

Page 18

background image

15

REV 92500-20140519

ENGLISH

92500

OPERATION

Log Splitter Operation

1. ALWAYS wear ear and eye protection, protective clothing

and safety gear.

Log Splitter Operation Cont’d.

HORIZONTAL position is used for lighter logs that
can easily be loaded onto the beam.
VERTICAL position is used for light logs as well as
heavy logs that are difficult to load onto the beam.
Back injury can result from lifting logs onto the log
splitter if proper lifting techniques are not used.

NOTE

It is normal for the hydraulic fluid to appear foamy/
frothy during operation. This can be caused by
agitated oil in the tank collecting air.

NOTE

If a log gets stuck, embedded or will not split
completely, push the control handle in the reverse
direction and allow the splitter to strip the log from
the wedge.
ALWAYS keep hands clear of the log and wedge
while it is retracting.

NOTE

2. Block tires and ensure support leg is secure to

prevent unintended movement of the log splitter
during operation.

3. Set log splitter in either the horizontal or vertical

position.

4. Load a log onto the beam against the end plate

(MAX LOG LENGTH – 23.8 in. [60.3 cm]).

5. Make sure all limbs are clear of crush zones.
6. Push the control valve handle forward (towards the

end plate) to split the log.

7. Push the auto control valve handle backward to

return the wedge to its original position.

8. Clear the split wood from the work zone.

The cylinder stroke is designed so the wedge stops
approximately 1.5 in. (3.8 cm) from the end plate.

NOTE