Champion Power Equipment 91050 - Manual (Page 13)

REV 91050-20140620
10
91050 ENGLISH
ASSEMBLy
Collection Bag Cont’d. 4) Install the Chute Deflector
1. Align the chute deflector (#57) and the hinge
spacers (#58) up with the hinge mounting holes on
the flailing housing. (A)
2. Slide bolt M6x100 (#45) through the hinge
mounting holes, hinge spacers, and chute deflector.
3. Secure with lock nut (#22). Tighten. Do not
overtighten.
4. Slide knob bolt (#59) through lock washer (#30)
and washer (#13) and then through chute deflector
and lower flailing housing assembly.
5. Tighten knob bolt. Do not overtighten.
6. Repeat for second knob bolt.
Collection Bag
The collection bag can be attached and removed from
the chute deflector using the adjustable drawstring. It
is recommended to be attached before operation and
removed before completely full, after operation, or
before storage. The collection bag will collect up to 2
bushels (70 L) of material.
Always inspect the collection bag prior to use. Do
not use a frayed, worn, or damaged collection bag.
NOTE
Before operation, ensure the adjustable drawstring
is tight around the chute deflector and secure.
WARNING
Once the collection bag appears to be almost full, it
is recommended to empty it. This will help to keep
the bag from becoming dislodged from the deflector
chute and also to keep the bag from bursting. Do
not allow the collection bag to become dislodged
from the deflector chute during operation. If this
occurs stop operation at once and let unit cool
before reconnecting the collection bag. Only empty
the collection bag when the engine is off and the
spark plug has been disconnected.
WARNING
The engine is equipped with a low oil shut-off and
the will stop when the oil level in the crankcase
falls below the threshold level.
CAUTION
Add Engine Oil
1. Make sure the chipper-shredder is on a flat, level
surface.
2. Remove oil fill cap/dipstick to add oil.
3. Add up to 1.2 qt. (1.1 L) of oil and replace oil fill
cap/dipstick. DO NOT OVERFILL.
4. Check engine oil level daily and add as needed.
DO NOT attempt to crank or start the engine before
it has been properly filled with the recommended
type and amount of oil. Damage to the chipper-
shredder as a result of failure to follow these
instructions will void your warranty.
CAUTION
Check oil often during the break-in period. Refer to
the Maintenance section for recommended service
intervals.
NOTE
22
45 57
58
59
30
13
B A