Champion Power Equipment 42432 - Manual (Page 13)

REV 42432-20121015
10
42432 ENGLISH
OPERATION
Surge Protection
Electronic devices, including computers and many
programmable appliances use components that are
designed to operate within a narrow voltage range and
may be affected by momentary voltage fluctuations .
While there is no way to prevent voltage fluctuations, you
can take steps to protect sensitive electronic equipment .
1. Install UL1449, CSA-listed, plug-in surge suppressors
on the outlets feeding your sensitive equipment.
Surge suppressors come in single- or multi-outlet
styles . They’re designed to protect against virtually
all short-duration voltage fluctuations .
Voltage fluctuation may impair the proper
functioning of sensitive electronic equipment .
CAuTION
If the engine starts but does not run make certain
that the generator is on a flat, level surface . The
engine is equipped with a low oil sensor that will
prevent the engine from running when the oil level
falls below a critical threshold .
NOTE
Starting the Engine
1 . Make certain the generator is on a flat, level surface .
2 . Disconnect all electrical loads from the generator .
Never start or stop the generator with electrical
devices plugged in or turned on .
3 . Turn the Fuel Valve to the “ON” position .
4 . Flip the engine switch to the “ON” position .
5 . Move the choke lever to the “CHOKE” position .
6 . Pull the starter cord slowly until resistance is felt and
then pull rapidly
7 . Do not over-choke . As as soon as engine starts, move
the choke lever to the “RUN” position .
Keep choke lever in “Choke” position for only 1
pull of the recoil starter . After first pull, move choke
lever to the “Run” position for up to the next 3
pulls of the recoil starter . Too much choke leads to
sparkplug fouling/engine flooding due to the lack of
incoming air . This will cause the engine not to start .
NOTE
Grounding
The generator system ground connects the frame to the
ground terminals on the power panel .
– The generator (stator winding) is isolated from the
frame and from the AC receptacle ground pin .
– Electrical devices that require a grounded receptacle
pin connection may not function properly .
Generator Location
NEVER operate the generator inside any building,
including garages, basements, crawlspaces and sheds,
enclosure or compartment, including the generator
compartment of a recreational vehicle . Please consult
your local authority . In some areas, generators must
be registered with the local utility . Generators used at
construction sites may be subject to additional rules and
regulations . Generators should be on a flat, level surface
at all times . (Even while not in operation) Generators
must have at least five feet of clearance from all
combustible material . In addition to clearance from all
combustible material, generators must also have at least
three feet of clearance on all sides to allow for adequate
cooling, maintenance and servicing . Generators should
never be started or operated in the back of a SUV,
camper, trailer, in the bed of a truck (regular, flat or
otherwise), under staircases/stairwells, next to walls or
buildings, or in any other location that will not allow for
adequate cooling of the generator and/or the muffler .
DO NOT contain generators during operation . Allow
generators to properly cool before transport or storage .
Place the generator in a well-ventilated area . DO NOT
place the generator near vents or intakes where exhaust
fumes could be drawn into occupied or confined
spaces . Carefully consider wind and air currents when
positioning generator .
Failure to follow proper safety precautions may void
manufacturer’s warranty.
Do not operate or store the generator in rain, snow, or
wet weather .
Using a generator or electrical appliance in wet
conditions, such as rain or snow, or near a pool or
sprinkler system, or when your hands are wet, could
result in electrocution .
WARNING
WARNING
During operation the muffler and exhaust fumes
produced will become hot . If adequate cooling and
breathing space are not supplied, or if the generator
is blocked or contained, temperatures can become
extremely heated and may lead to fire .