Burris XTR II - Manual (Page 6)

Illuminated Reticle Adjustment
Models with an illuminated reticle make it easier to see
the reticle in low light conditions.The intensity of the
illumination is controlled by the rotary illumination
switch located on the left side of the adjustment turret.
The switch has 11 intensity levels and a “battery saver”
position in between each level that turns off the
illumination. The illumination levels rise in brightness
intensity from 1–11, with the lowest levels capable of
working with night vision equipment, the middle levels
ideal for low light conditions, and the highest levels
suitable for daytime usage. The “Off” positions at the
minimum and maximum ranges turn the circuit off
completely and should be used when the scope is not
in use. Each level also has a detent to prevent unintended
changes during use.
Time-Out Function: XTR II Riflescopes arrive from the
factory with an automatic Time-Out Function. After XX
hours the illumination will automatically shut off to
conserve battery life. This function can be disabled by
Burris upon request or you can deactivate the setting
yourself. To learn how, visit www.burrisoptics.com/XTRII
or contact our customer service department.
The reticle is powered by a 3-volt lithium cell battery
#CR2032. To install a new battery, simply unscrew the
battery cap on the rotary switch and install the new
battery flat side (+) up. It is advisable to remove the
battery for long-term storage (over a month).
5