Behlen 80110710ORG - Manual (Page 3)

BEFORE YOU START!!
Read the safety messages on the implement
and as shown in the manual. Observe the
rules of safety and common sense!
Important Safety Information
Working with unfamiliar equipment can lead to
careless injuries. Read this manual and the
manual for your tractor before assembly or
operating, to acquaint yourself with both
machines. It is the Owner/Operator’s
responsibility, if this machine is used by any
person other than yourself, or is loaned or
rented, to make certain prior to operating:
1. The operator’s manual is read and
understood.
2. Safety issues are understood and followed,
and proper usage is understood.
The use of this equipment is subject to certain
hazards which cannot be protected against by
mechanical means or product design. All
operators of this equipment must read and
understand this entire manual, paying particular
attention to safety and operating instructions,
prior to use. If there is something in this manual
you do not understand, ask your dealer or
manufacturer, to explain it to you. Improper use
can occur on machines that are loaned out or
rented to someone who has not read the
owner’s manual and is not familiar with a Grader
Blade.
Safety
Information
This Grader Blade was designed
for one-man operation from the
tractor seat. Most accidents occur
because of neglect or
carelessness. It is the responsibility
of the operator to see that no one is within
twenty-five feet (25’) of the blade when it is in
operation. Do not operate the implement with
another person near, or in contact with, any part
of the Grader Blade. Serious personal injury or
death may result if any attempt is made to assist
operation by hand.
Only properly trained people
should operate this machine.
It is always recommended the
tractor be equipped with a
Rollover Protection System
(ROPS) and a seat belt that is
used. Always stop the PTO,
set break, shut off the tractor engine, remove the
tractor key, and allow implement to come to a
complete stop before dismounting tractor. Never
leave equipment unattended with tractor
running.
The use of this equipment is subject
to certain hazards which cannot be
protected against by mechanical
means or production design. All
operators of this equipment must
read and understand this entire manual, paying
particular attention to safety and operating
instructions, prior to using. If there is something
in this manual you do not understand, ask your
supervisor, or your dealer, to explain it to you.
Please remember it is important that you read
and heed the safety signs on the Grader Blade,
and the safety rules set forth herein. Clean or
replace all safety stickers if they can not be
clearly read and understood. They are there for
your safety as well as the safety of others. The
safe use of this machine is strictly up to you, the
operator.
All things with moving parts are potentially
hazardous. There is no substitute for a
cautious, safety-minded operator who
recognizes potential hazards and follows
reasonable safety practices. The
manufacturer has designed this implement
to be used with all its safety equipment
properly attached, to minimize the chance
of accidents. Study this manual to make
sure you have all the safety equipment
attached.
When maneuvering close to buildings or
passing through narrow areas, be sure to
allow sufficient clearance for the
implement and tractor. NEVER operate
tractor and implement under trees with low
hanging limbs. Operators can be knocked
off tractor and run over by implement.
This Grader Blade is only designed for
speeds less than 5 mph. Reduce speed
on rough surfaces.
OPERATION & MAINTENANCE INSTRUCTIONS
F-20830 1-10-11