AXEON DT-Series User Manual
Page 8

DT – Series User’s Manual
MKTF-208
NOTE: IT’S RECOMMEND
SYSTEM IN ACCORDANCE WITH LOCAL AND NATIONAL ELECTRICAL CODES
(NEC).
WARNING: TO REDUCE THE RISK OF ELECTRICAL SHOCK, THE
INCOMING POWER SUPPLY MUST INCLUDE A PROTECTIVE EARTH GROUND.
DT-Series systems are typically controlled with a liquid level switch in a storage tank.
The liquid level switch turns the system on when the water level in the tank drops, and
off when the tank is full. Liquid level switches can be obtained by your local dealer or
distributor. If a liquid level switch is to be used, install it at this time.
PRE-FILTRATION
DT-Series systems are supplied with a 10 Micron FSI Bag Filter and a 4.5” x 20” 5
Micron polypropylene sediment filter
15 psi differential exists between the pre
Pre-Filtration systems, if required.
NOTE: THE SYSTEM MUST BE OPERATED ON FILTERED WATER ONLY.
PUMP
The pump type used on the DT
pump. These pumps are also available
Follow these guidelines to ensure proper operation of the pump:
The pump must NEVER
water will damage the pump.
ALWAYS feed the pump with filtered water. The pump is susceptible to damage
from sediment and debris.
8
RECOMMENDED THAT A LICENSED ELECTRICIAN WIRE YOUR
SYSTEM IN ACCORDANCE WITH LOCAL AND NATIONAL ELECTRICAL CODES
WARNING: TO REDUCE THE RISK OF ELECTRICAL SHOCK, THE
INCOMING POWER SUPPLY MUST INCLUDE A PROTECTIVE EARTH GROUND.
typically controlled with a liquid level switch in a storage tank.
The liquid level switch turns the system on when the water level in the tank drops, and
Liquid level switches can be obtained by your local dealer or
If a liquid level switch is to be used, install it at this time.
supplied with a 10 Micron FSI Bag Filter and a 4.5” x 20” 5
Micron polypropylene sediment filter. Change the cartridge once a month or when a 10
ists between the pre-filter. Ask your local dealer or distributor about
Filtration systems, if required.
NOTE: THE SYSTEM MUST BE OPERATED ON FILTERED WATER ONLY.
type used on the DT-Series systems is a multi-stage centrifugal
also available as an option in stainless steel
Follow these guidelines to ensure proper operation of the pump:
NEVER be run dry. Operating the pump without sufficient feed
will damage the pump.
feed the pump with filtered water. The pump is susceptible to damage
from sediment and debris.
06/12
THAT A LICENSED ELECTRICIAN WIRE YOUR
SYSTEM IN ACCORDANCE WITH LOCAL AND NATIONAL ELECTRICAL CODES
WARNING: TO REDUCE THE RISK OF ELECTRICAL SHOCK, THE
INCOMING POWER SUPPLY MUST INCLUDE A PROTECTIVE EARTH GROUND.
typically controlled with a liquid level switch in a storage tank.
The liquid level switch turns the system on when the water level in the tank drops, and
Liquid level switches can be obtained by your local dealer or
supplied with a 10 Micron FSI Bag Filter and a 4.5” x 20” 5
month or when a 10-
r or distributor about
NOTE: THE SYSTEM MUST BE OPERATED ON FILTERED WATER ONLY.
centrifugal carbon steel
in stainless steel.
be run dry. Operating the pump without sufficient feed
feed the pump with filtered water. The pump is susceptible to damage