Attach shelter to frame – Coleman GEOSPORT 9392-2301 User Manual
Page 2
5
PRINTED IN SRI LANKA
Rev. 11/04
Things You Should Know
•
Never store shelter, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles inside
your shelter. Use separate storage bag.
•
STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE SHELTER FABRIC OR SHELTER STAKE LOOP TO
REMOVE STAKE.
•
SHELTER POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER
DURING STORAGE.
•
Do not leave your shelter set-up for weeks at a time, be aware that expo-
sure to the ultraviolet rays of the sun can seriously damage material and/or
cause it to become discolored.
WARNING: Keep all flame and heat sources away from this tent fabric.
This shelter meets the flammability requirements of CPAI-84. The fabric will
burn if left in continuous contact with any flame source. The application of
any foreign substance to the shelter fabric may render the flame-resistant
properties ineffective.
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN SRI LANKA
Attach Shelter to
Frame
–Drape the canopy over the frame (illus. 5)
–Position each corner over a Leg Hub
–Fully extend each pole by
completing the interlocking of the
shock corded pole sections.
–Insert the brass hook into the hole
near the base of the pole (illus. 6, 8)
–From the inside of the shelter secure
the pole frame to the shelter with the
hook and loop closures.
–Adjust poles to pull the shelter taut
and stake down through the fabric
loops at the end of each pole
–Adjust hook straps to increase
tautness (illus. 7)
–Attach guy lines to fabric
guy loops at each corner
and stake out (illus. 7)
illus. 5
Shelter draped over
partially assembled frame
illus. 6
Insert Brass Hook
into hole near the
base of the
illus. 8
Completed shelter with guy lines
staked out
illus. 7
Stake through
Stake Loop
Use to adjust or
tighten canopy