Audio Unlimited spk-velo-003 Owners Manual User Manual

Page 4

P.6

OPERATION

Turn on the audio source to which the transmitter is connected.

Set volume of audio source to 75% to send a strong consistent signal to the

transmitter.

Set the POWER switch on the back of the transmitter to the ON position. The LED

on the transmitter will show a steady BLUE light if the source signal is strong

enough or flash if the transmitter requires a higher source device volume level.

Select the channel 1 or 2 of the transmitter for best performance in your location.

Turn on the speaker and adjust the volume to the desired listening level. Volume

can be adjusted up by pressing “+” button or down by pressing the “-“ button to the

desired listening level, or you can press the “+” button or “-“ button” on the remote

control unit to adjust the volume level.

Press the “AUTO TUNE” button to get the best tuning reception from your

speakers. When the button is pressed, frequency tuning starts automatically and it

stops when a signal is detected. Tuning process can also be activated by pressing

the “AUTO TUNE” button on the remote control unit.

NOTE :

a.)

During initial setup keep the Speakers 21 feet (or less) away from the

transmitter, and press “AUTO TUNE” button for the best reception.

P.7

b.)

Whenever you find frequency jam, select other Channels on the transmitter,

and then press the “AUTO-TUNE” button again.

c.)

Low or distorted sound on speakers or with a transmitter powered by batteries

can be caused by batteries that are discharged or have low capacity. Test by

removing batteries and connecting the AC power adapter or using a fresh set

of batteries.

Battery Precautions

If using batteries in the transmitter or speakers

Only use AA batteries in the transmitter, C cell batteries in the speaker, and AAA

batteries in the remote control.

Batteries may leak or explode if inserted improperly, disposed of in fire, or mixed with

different types.

Alkaline batteries may leak or explode if placed in a battery charger.

When installing batteries, observe proper +/- polarities. Batteries positioned

incorrectly may leak and cause damage to the unit.

Never attempt to recharge conventional dry cell batteries.

Replace only with fresh, new batteries.