Audio Unlimited spk-4gx - Manual (Page 8)

Remote Control
1. The remote control is ready to use with a factory-installed button cell battery. It can be stored in
the recessed area on the front panel.
2. Press “+” “-” button to get desired volume level.
3. Press the Light button to turn on/off the Mood light feature.
4. When the speaker is on, pressing the “Power” button puts it in standby mode. The speaker
BLUE light changes to GREEN.
5. Pressing the “Power” button while the speaker is in standby mode puts it back to active mode.
The GREEN light changes to BLUE.
NOTE: The remote control can be used to raise or lower the volume or change the status of the
speaker from active to standby or from standby to active. If the speaker is completely powered
off, the remote will not power the system up.
Basic Operation
1. When the transmitter is plugged in or batteries are inserted, turn the “On/Off” switch to ON.
The transmitter's light will be GREEN.
2. To turn on the speaker, press and hold the POWER button on the front panel of the speaker for 3
seconds. The Power button‟s light will be GREEN.
3. Turn on the audio source and set the source volume to 75% of maximum. The BLUE light on
the transmitter and speaker illuminate when the audio signal link between the two is made.
This will typically take no more than 5 seconds.
4. If the audio source connected to the transmitter is turned off for less than 4 minutes, the BLUE
lights on the transmitter and the speaker remain on, but no sound is transmitted. When the
audio signal is turned back on, sound is transmitted again.
5. If no signal is detected for more than 4 minutes, the transmitter automatically turns off and goes
into STANDBY mode. The BLUE lights on the transmitter and the speaker switch to GREEN.
6. If no audio signal is detected from the transmitter for more than 15 minutes, the speaker
automatically turns off. The GREEN LED goes off.
7. To turn speakers on, press the POWER button on the front panel of the speaker for 3 seconds.
8. To turn the speakers off, press the POWER button on the front panel for 3 seconds.
PAIRING
1. PAIRING is needed when 2 or more speakers are being used with the same audio source. (With
optional purchase of additional SPK-24GX speaker).
2. Press the „Pair‟ button on the transmitter and the „Light/Pair‟ button on one of the speaker for 5
seconds there will be an audio test tone when the pairing process is finished.
3. The first speaker is now paired and memorized by the transmitter.
4. Repeat the procedure on the second speaker by pressing the “Pair” and the “Light/Pair” button
on the transmitter and the second speaker respectively.
5. Repeat this procedure on any additional speakers.