beautypg.com

Audio Unlimited spk-velo-4kit2 Owners Manual User Manual

Page 6

background image

P.10

TECHNICAL SPECIFICATIONS

Transmission Mode

: UHF

Carrier Frequency

: 900 MHz Digital Hybrid

Operation Voltage

: Transmitter, DC 12V 200mA

Speakers, 6 X ‘C’ size Alkaline batteries or DC 9V 1A adaptor

Remote Control Unit, 2 X ‘AAA’ size batteries

Frequency Response : 40Hz – 12KHz

Distortion

: 1%

S/N Ratio

: 65dB (typical)

Operation Distance

: Up to 150 feet

Speakers

: 2-way

Output Power

: 2 x 5Watts

NOTE: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in

a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

P.11

This product may contain chemicals listed in Proposition 65

(

http://www.oehha.ca.gov/prop65/prop65_list/Newlist.html

)

that may

be known to cause cancer, birth defects or other reproductive harm.

ATTENTION:

The transmitter for this speaker set is designed to work with a wide variety

of devices. Our tests show the default volume levels of iPods, MP3 players

and other devices connected to the transmitter through the headphone jack

does not have the signal strength required by the transmitter. Raising the

volume of your device will increase the signal strength to the transmitter.

The blue signal LED will switch from flashing to steady when the

required signal strength from your device is reached. We recommend that

you keep the volume set on your iPod or MP3 player at a minimum of ¾ of

full volume.

WARNING:

When powering by AC household current, these devices must be used with

the AC/DC adapters supplied within the package. Do not attempt to

power utilizing other AC or DC adapters. Power adapters are for indoor

use only – do not use in wet areas or weather.