Audio Note AZ-Three Speaker - Manual (Page 9)

BEFORE ATTEMPTING TO CONNECT THE AZ-THREE TO YOUR AMPLIFIER,
ENSURE THAT IT IS DISCONNECTED FROM THE MAINS SUPPLY!
Choose loudspeaker cables that are long enough to comfortably reach from your
amplifier to the AZ-THREE without stretching or pulling tightly; it is always better to
have a loudspeaker cable that is too long rather than too short!
On the rear of each loudspeaker are two pairs of binding posts.
Viewed vertically, the two on the LEFT are for HIGH FREQUENCY (HF).
The two on the RIGHT are for LOW FREQUENCY (LF).
Each binding post is colour coded either
RED or BLACK.
The RED binding posts (top two) connect to the RED / POSITIVE (often marked ʻ + ʼ)
loudspeaker outputs on your amplifier.
The BLACK binding posts (bottom two) connect to the BLACK / NEGATIVE (often
marked ʻ-ʻ) loudspeaker outputs on your amplifier.
CONNECTION
HF
LF
BLACK /
NEGATIVE (-)
RED /
POSITIVE (+)
HIGH
FREQUENCY
(HF)
LOW
FREQUENCY
(LF)