Audio Note Meishu Phono - Manual (Page 9)

Line inputs Four line level inputs are available for connection to CD, Aux, Tuner
and Tape In.
Connect the ‘Line Out’ sockets of your Recording device to the ‘Tape
In’ sockets of the Meishu, and the ‘Tape-Out’ sockets on the Meishu to
the ‘Line In’ sockets of your Recording device.
Phono input The Meishu Phono is equipped with a high quality, valve, Moving
Magnet (MM) phonostage. Connect the cables from your tonearm to
the ‘Phono’ socket inputs. If your turntable is equipped with a separate
earth wire, connect this to the dedicated grounding / earth post,
located next to the ‘Phono’ input sockets.
If you wish to use a low output Moving Coil (MC) cartridge, Audio Note
manufactures a series of Step Up Transformers for this purpose. For
further information, please contact your Audio Note (UK) Dealer, or
alternatively please contact us direct.
Ground Post A ground post is provided for connection to those source components
that also use a separate ground terminal.
Speakers
Each channel is equipped with 3 colour coded binding posts for
connection to your speakers.
Looking from the front of the amplifier, the 3 binding posts to the left
are for the left channel and the 3 binding posts to the right are for the
right channel.
Connect the amplifiers black speaker output binding post marked as
“0” to the black / negative terminal (also marked “ – “) on the speaker.
Connect the amplifiers red speaker output binding post marked “8
Ohm” to the red / positive terminal (also marked “ + “) on the speaker.
The other red speaker output binding post is marked “4 Ohm” and
may be used with 4 Ohm speakers. If you are uncertain whether your
speaker system is specified as 4 or 8 Ohm, try the following test once
all other connections are made and the amplifier is operational.
Compare the sound quality using a familiar recording with the
speakers connected to the 8 ohm connections and then the 4 Ohm
connections respectively. The selection that produces the best
frequency balance and maximum dynamics should be used.
Mains The Meishu utilizes an IEC 320 mains inlet socket. Use the supplied
mains cable to connect the unit to the local mains supply. The mains
fuse and a spare is located in the inlet socket fuse drawer.
CONNECTION