Audio Note M8 Phonosig - Manual (Page 4)

Connections
Phono input
The phono input is suitable for connection to a turntable with a moving magnet (MM) cartridge installed.
Audio Note is able to provide a range of step-up transformers for use with moving coil (MC) cartridges.
These transformers are able to provide the best possible match for the M8 Phono Signature. The phono
input consists of a pair of RCA connectors.
NOTE: Some turntables are equipped with a separate ground wire for connection to the ground
terminal next to the phono input sockets. We recommend that this terminal is used, however, in
some systems this may cause a ground loop. This will be identifiable by excessive background
hum. It is therefore worthwhile to experiment a little to find the connection method that yields the
lowest background noise levels.
Line input
Eachline input is suitable for connecting to any line level music source. Line level sources include CD
players, radio tuners, televisions etc.Each line input consists of a pair of RCA connectors.The M8 Phono
Signature has 5 line inputs available.
Tape loop
The tape loop is available for connecting to a cassette desk. The 'tape in' connections should be
connected to the cassette deck's 'line out' and the 'tape out' connections should be connected to the
cassette desk's 'line in'. The tape in can be used as an additional line input if required. The RCA
connectors are marked red for the right channel and white for the left channel.
Balanced output
The balanced outputs are provided to be used with power amplifiers equipped with a balanced input
option. Using the balanced option can sometimes result in a better sound quality, depending on the
exact deign of the power amplifier.
Unbalanced output
There are 2 sets of unbalanced outputs are provided for Bi-amplified systems. Both sets are identical and
may be used for single amplifier operation. The connectors are marked red for the right channel and
white for left channel.
NOTE: The balanced/unbalanced selection switch must be set to the appropriate position. It is not
recommended to use both the balanced and unbalanced outputs simultaneously.
Mains power connection
Use the supplied cable to connect the IEC inlet socket on the pre-amplifier to the mains supply. Ensure
the power is switched off when you do this.
NOTE: It is important that all connections are firm, secure and airtight. any oxidisation of the
interconnects will result in loss of performance. Always use high quality interconnects - Audio
- 4 -