Audio Note M8 Phono - Manual (Page 8)

Line inputs Three RCA / Single Ended line inputs are available for connection,
labeled ‘Tuner’ ‘Aux’ and ‘CD’; any standard ‘line level’ source can be
connected to these inputs.
All sockets are colour coded;
RED is for RIGHT channel connection,
WHITE is for LEFT channel connection.
Phono input The M8 Phono is equipped with a high quality, valve, Moving Magnet
(MM) phonostage. Connect the cables from your tonearm to the
‘Phono’ socket inputs. If your Turn Table is equipped with a separate
earth wire, connect this to the dedicated grounding / earth post,
located next to the ‘Phono’ input sockets.
If you wish to use a low output Moving Coil (MC) cartridge, Audio Note
(UK) manufactures a series of Step Up Transformers for this purpose.
For further information, please contact your Audio Note (UK) Dealer,
or alternatively please contact us direct.
Mains The M8 Pre Amplifier is equipped with an IEC 320 mains inlet socket.
Use the supplied mains cable to connect the unit to the local mains
supply. The mains fuse and a spare is located in the inlet socket fuse
drawer.
Special Note – Make sure that all connections are tight and clean. For
best results use good quality audio interconnects. Although it is
perfectly acceptable to use cables manufactured by other companies,
for best results and performance, we recommend our own Audio Note
(UK) range of interconnects and loudspeaker cables. For further
information, please consult your nearest Audio Note (UK) dealer, or
alternatively please feel free to contact us directly.
Ground Post A ground post is provided for connection to those source components
that also use a separate ground terminal.
Outputs
The M8 Pre Amplifier provides two Single Ended outputs, consisting of
two pairs of colour coded RCA / Single Ended sockets.
RED is for
RIGHT channel connection, WHITE is for LEFT channel connection.
There is also a balanced output, consisting of a pair of ‘male’ XLR
sockets (see ‘Balanced’ section, below).
RCA
The two pairs of RCA / Single Ended outputs are for connection to a
power amplifier and are identical, making them suitable for bi-amping.
CONNECTION
RCA SOCKET,
CENTRE = POSITIVE / SEND.
RCA SOCKET,
SHELL = NEGATIVE / RETURN.