Artison RCC320r User Manual
Page 6

6
PAINTING THE GRILLE & TRIM RING
1. The Grille and Trim Ring can be painted separately from the rest of the subwoofer module.
2. Carefully remove the thin fabric scrim cloth from the interior of the grille. The scrim is not to be painted.
Replace scrim cloth after painting is completely dry. If the scrim does not adhere to the grille again use a
spray adhesive to reattach.
3. DO NOT get paint on the speaker baffle or speaker cones. Paint can damage these components
which would VOID your Warranty.
INSTALLATION OF PRE-CONSTRUCTION MODULE INTO CABINETRY
1. The module comes with the Pre-Construction Paint/Debris Shield in place. DO NOT REMOVE this shield
until after the room painting is completed.
2. The subwoofer module can also be concealed inside of any piece of furniture or built-in cabinetry. The unit
can be installed face-down inside a cabinet and direct the subwoofer’s energy down through the bottom of
the cabinet; directly into the room or out through venting in the cabinet’s baseboard.
3. Dimensions for the thru hole cut-out are 342 x 78 mm (13.5” x 3.1”). Please note the thickness of the
cabinet wall must at least be 0.5” if the grille is going to be visible.
4.
When venting the output of the subwoofer through a built-in cabinet’s baseboard, please reference the
points below:
a. Please allow for a minimum of 50 in
2
of total open area in the baseboard. If less open area is provided
the subwoofer will be restricted and may cause noise through the vent.
b. Rounded corners will also minimize air noise.
c. The subwoofer is not affected by variations in shape or number of vents, as long as the minimum total
open area is maintained.
INSTALLATION OF PRE-CONSTRUCTION MODULE IN CEILING
1. The subwoofer module can also be installed in joist bays. Minimum distance between studs must
accommodate the module dimensions of 342 mm (13.4”) x 354 mm (13.9”).
INSTALLATION OF PRE-CONSTRUCTION MODULE UNDERNEATH / BEHIND FURNITURE
1. Due to the modules thin form factor, the unit can also be hidden underneath or behind furniture.
Minimum clearance height is 127 mm (5.0”).