Lipo nimh battery mode on off reverse – ARRMA AR102601 User Manual
Page 7

WWW.ARRMA-RC.COM
© 2013 ARRMA Durango Ltd. A subsidiary of Hobbico, Inc.
7
Temperature Protection
Low Voltage Cut Off
Unterspannungsabschaltung
Coupure Basse Tension
Corte de bajo voltaje
低電圧カットオフ
低电压保護
ESC Tuning
Temperatursicherung
Reglerabstimmung
Protection de température
Réglage du variateur électronique
Protección por temperatura
Ajuste del ESC
温度保護
ESC のチューニング
温度保护
ESC 调整
ESC Status LED
Regler-Status-LED
Le statut des LED du variateur électronique
Indicador LED del ESC
ESC ステータス LED
If the ESC temperature exceeds 80 degrees Celsius for 5 seconds or longer, the ESC will enter temperature protection mode and the status LED will blink quickly.
Once the ESC has cooled down it will resume normal operation.
The MEGA brushed ESC has two tuning options - battery mode and reverse lock out. The setting of these modes can be changed by moving the position of the setting ‘jumpers’
Für den Fall, dass der Regler eine Temperatur von 80°C für länger als 5 Sekunden erreicht, wird er in den Temperatur-Schutzmodus gehen, was durch ein schnelles
Blinken der LED angezeigt wird. Nach dem Abkühlen kann der normale Betrieb fortgesetzt werden.
Der MEGA Bürstenmotor-Regler verfügt über zwei einstellbare Parameter: Batteriemodus und Rückwärtsgangsperre. Die Einstellungen können über die entsprechenden “Brücken” eingestellt werden.
Si la température du variateur électronique excède 80 degrés Celsius au moins 5 secondes ou plus, le variateur électronique entera automatiquement en mode de
protection de température et les LED clignoteront rapidement. Une fois que le variateur électronique aura refroidi, il se remettra à fonctionner normalement.
Le variateur électronique MEGA a 2 réglages supplémentaires – Type de Batterie et Marche Arrière bloqué. Le choix et changement de ces deux réglages peut se faire en changeant la position du Pont de réglage.
Si la temperatura del ESC supera los 80º C durante 5 segundos o más, el ESC entrará en modo de protección por temperatura y el indicador LED parpadeará
rápidamente. Una vez se reduzca la temperatura el ESC volverá a funcionar con normalidad
El ESC de escobillas MEGA cuenta con dos opciones de ajuste - tipo de batería y bloqueo de marcha atrás. El ajuste de estas opciones se puede variar moviendo los puentes de ajuste
ESC の温度が 5 秒以上 80℃を超えると ESC は温度保護モードとなり、ステータス LED が素早く点滅します。ESC の温度が下がると通常に作動します。
MEGA ブラシモーター ESC には、バッテリーモードとリバースロックアウトの 2 つのチューニングオプションがあります。モード設定の変更はセッティングジャンパーの位置を移動して行います。
如果 ESC 温度超过 80 摄氏度持续 5 秒或更长的时间,ESC 将进入温度保护模式和状态指示灯将快速闪烁。一旦 ESC 冷却下来,将恢复正常运行。
MEGA 有刷 ESC 有两个微调选项 - 电池模式和逆转锁定。这些模式设置可以改变移动设置跳线的位置“
ESC 状态 LED
Battery Mode
Batteriemodus
Type de batterie
Tipo de batería
バッテリーモード 电池模式
NiMh
LiPo
Cut-off Voltage
Abschaltungsspannung
Coupure de tension Corte de voltaje
カットオフ電圧
截止电压
4.5v
6.2v
LiPo
NiMh
BATTERY
MODE
ON
OFF
REVERSE
ESC Specifications Reglerspezifikationen Spécifications du variateur électronique Especificaciones del ESC
ESCの仕様 ESC规格
Input Voltage
Eingangsspannung
Voltage d’entrée
Voltaje de entrada
入力電圧 輸入電壓
6-7 NiMh (7.2-8.4v) / 2S Lipo (7.4v)
BEC Output BEC Ausgang Sortie BEC
Voltaje de salida del BEC
BEC 出力
免电池电路 (BEC) 输出
6.0v/2A Max
LED off: Neutral throttle
LED blinking slowly: Partial Forward/Reverse/Brake
LED solidly on: Full Forward/Reverse/Brake
LED aus: Gas/Bremse neutral
LED blinkt langsam: Teilgas/-rückwärts/-bremse
LED permanent an: Vollgas/-rückwärts/-bremse
LED éteintes :
Accélération au neutre
LED clignotant lentement : Marche Avant/Marche Arrière/Freinage en
fonctionnement partiel
LED Allumés : Marche Avant/Marche Arrière/Freinage
en fonctionnement complet
Indicador LED apagado:
Acelerador neutro
Indicador LED parpadeando lentamente: Acelerador/Marcha atrás/Freno
accionado parcialmente
Indicador LED encendido permanentemente: Acelerador/
Marcha atrás/Freno accionado completamente
LED がオフ: ニュートラルスロットル
LED がゆっくり点滅: ハーフスロットル / リバース / ブレーキ
LED が点灯: フルスロットル / リバース / ブレーキ
LED 关闭:油门中立点
LED 指示灯缓慢闪烁:半正向 / 反向 / 刹车
LED 扎实:全正向 / 反向 / 制动
Setting 'Jumpers'
Einstellung “Brücke”
Pont de réglage
Puente de ajuste
Jumpers(ジャンパー)
の設定
设置“跳线”
Battery Mode: NiMh
Reverse: On
Tipo de batería: NiMh
Marcha atrás:
Activada
Batteriemodus: NiMH
Rückwärtsgang:
ein
バッテリーモード:
ニッケル水素バッテリー
リバース: ON
Type de batterie : NiMh
Marche Arrière :
Allumée
电池模式:镍氢电池
反向:开
Factory Defaults
Werkseinstellungen
Réglages d’usine
Defectos de fabricación
工場出荷時の設定
出厂默认值