AquaCraft 46 BB Marine Engine - Manual (Page 2)

In the event that you need to adjust the orientation of the exhaust outlet,
loosen the lock nut at the rear of the muffler and rotate the exhaust outlet
away from the vehicle. Re-tighten the lock nut at the rear of the muffler.
Attach fuel tubing to your fuel tank and route the tubing to the engine.
Use a minimum of tubing but be careful not to crimp the lines.
Pressure Line: The carburetor of your model engine requires consistent
fuel pressure when running. Pressure is created in the muffler by the
exhaust. Some of the pressure is used to pressurize the fuel tank. Attach
a piece of fuel tubing from the pressure fitting on the muffler to the vent
tube on the fuel tank.
Fuel Line: Connect the fuel line from the pick-up tube on the tank to
the fuel inlet on the carburetor.
Top Top
Vent (to Muffler)
Fill (Optional)
Fuel Pick Up Tube
(To Carburetor)
FUEL LINE INSTALLATION
Fill Line (Optional): This is the line that allows you to fill your tank
with fuel. It is important to be able to access this line easily. Use a fuel
line stopper (not included) to close off the end of the line after filling
the tank. Note: Most people just use the carb line to fill the tank.
1. Place the spinner back plate onto the crankshaft so that it rests
against the drive washer. Be sure to balance your propeller before
installation using a prop balancer such as the Top Flite
® Precision
Magnetic Balancer ™ (TOPQ5700).
2. Place the propeller onto the crankshaft so the blades rest against the
alignment pegs of the back plate and replace the prop washer.
3. Replace the prop nut. IMPORTANT: Tighten the prop nut firmly.
INSTALL THE SPINNER AND PROP