AquaCraft Bristol Bay - Manual (Page 3)

All pictures, descriptions, and specifications found in this
instruction manual are subject to change without notice.
AquaCraft maintains no responsibility for inadvertent errors in
this manual.
❏
DTXC2100 DuraTrax ® 7.2 volt 1500mAh NiCd battery
pack (1 required)
❏
DTXP4000 AC/DC Piranha ™ Peak Power charger
❏
FUGP7300 “AA” batteries. Ten (10) “AA” batteries are
required (8 for the transmitter, 2 for the lighting system)
BOW: The front of the boat.
STERN: The back of the boat.
PORT: This is the left side of the boat when aboard and facing
the front (bow). An easy way to remember this is that port and
left both contain four letters.
STARBOARD: This is the right side of the boat when aboard
and facing the front (bow).
HULL: The body of the boat.
DECK: The top of the boat.
Transmitter Assembly
Important Note: The transmitter is not water resistant and
should never come in contact with water.
❏
1. Remove the transmitter antenna from the parts bag and
screw it into the top of the transmitter. To ensure that the
antenna is attached, lightly pull on the base of the antenna. If
it slides out, it is not installed properly.
❏
2. Slide off the battery door
on the bottom of the transmitter.
Install eight (8) new “AA”
batteries into the bottom of the
transmitter in the configuration
molded into the battery holder.
Re-install the battery door onto
the bottom of the transmitter.
❏
3. Turn the transmitter “ON”
using the switch on the front. The
red LED light next to the on/off
switch should light up. If the LED
does not light up, turn the
transmitter off and check to
make sure that the batteries are
installed properly. If you see a
flashing LED, the batteries are
low and need to be replaced.
Hull
❏
1. Carefully remove the Bristol Bay and boat stand from
their packaging.
❏
2. Carefully remove the strips of tape that hold the deck
ornaments in place.
Mast & Sail Installation
❏
1. Lift the cabin gently and release the port (left) and starboard
(right) cabin hooks from their retaining rings as shown.
❏
2. Carefully remove the mast and sails from their packaging.
Be careful of the electrical wiring for the mast lighting.
ON / OFF
THROTTLE SERVO
REVERSE
STEERING
SERVO
REVERSE
POWER
LIGHT
STEERING
TRIM
ADJUSTABLE
STEERING
RATE
THROTTLE
TRIM
Install (8) new "AA" batteries
FINAL ASSEMBLY
BOAT TERMINOLOGY
ITEMS REQUIRED FOR COMPLETION
SPECIFICATION & DESCRIPTION CHANGES
3