AquaCraft Atlantic II - Manual (Page 4)

4
Understanding Your Transmitter
To help you better understand your transmitter and its functions,
here is a picture outlying the operation features, servo reversing
and receiver assignments (* not used with this product).
SERVO REVERSING AND RECEIVER ASSIGNMENTS
CH 1 = Steering (right stick, left and right)
*CH 2 = AUX 2 (momentary switch)
CH 3 = Throttle (left stick, up and down)
*CH 4 = AUX 1 (left stick, left and right)
Assembly Sequence
IMPORTANT NOTE: The transmitter is not water resistant and
should never come in contact with water!
Slide off the battery door from the back of the transmitter and
install 4“AA” batteries into the transmitter in the configuration
molded into the battery floor. Reinstall the battery door.
Turn the transmitter “ON” by shifting the power on switch to the
up position. The battery indicator light (LED) should glow red.
If the light is flashing and the transmitter beeping, the batteries
might be installed incorrectly or are low and need to be replaced.
To remove the cabin slide the “tool box” forward near the front
of the cabin.
Rotate the front of the cabin up and forward to remove it from
the hull.
Inside the cabin you will see two shorter wire sets with plug-ins.
Plug the two together. This is the connection from the lower
cabin to the upper cabin lighting system.