Antari Z-1520 RGB - Manual (Page 11)

Chase Speed 0-255 0-255 step per min
Channel 7 DMX Value Range Function
Master Dimmer 0-255 0-100%
Channel 8 DMX Value Range Function
Strobe 0-255 1-20 Hz
Fluid
Only use Antari FLC water-based liquid for the Z-1520 RGB Fogger. The machine is tested
and calibrated with this liquid to get the best output performance. Warranty will be void if any
other type of liquid is used, improper use of liquid may lead to machine failure and
malfunction.
Service and Maintenance
․ Do not allow the machine to become contaminated.
․ Remove dust from air vents with air compressor, vacuum or a soft brush.
․ Only use a damp cloth to clean the casing.
․ Before storing run distilled water through the system to help avoid condensing the pump
or heater.
․ It is recommended to run the machine on a monthly basis in order to achieve best
performance and output condition.
․ Excessive dust, liquid and dirt built up will degrade performance and cause overheating.
․
Breaker Reset
Disconnect AC power before resetting the breaker. Only replace fuse with same
type and rating.
Step 1: Disconnect AC power.
Step 2: Flip breaker to ON position.
Step 3: Turn on machine for testing.
11