American Diagnostic Corporation (ADC) 104BKE - Manual (Page 2)

A Special Thank You...
Thank you for choosing an ADC® emergency product. We're proud of the care and quality that goes
into the manufacture of each and every item that bears our name. Only the finest materials are used
to assure you of a timeless instrument designed for optimum performance. You'll quickly appreciate
the results, for you now own one of the finest emergency tools that money can buy. With proper care
and maintenance, your ADC® product is sure to provide you with many years of dependable service.
Please read the following instructions and general information which will prove helpful in allowing
you to enjoy your ADC® product.
Thank you for your patronage. It is indeed our pleasure to serve you.
Sincerely,
American Diagnostic Corp.
Care of your ADC® Nylon holster
Your ADC® Responder nylon holster is made from durable 1000D nylon, lined with cushioning
foam. Pocket Organizer is made from 420D nylon.
When soiled, wash by hand in cold water with a mild soap. Never use bleach. Allow holster to air dry.
Never iron over hook & loop fasteners-heat from the iron will damage them.
The instrument pockets might be tight initially, but will stretch within a few weeks. Never overload
nylon holsters as this may damage the seams or cause the nylon to wear prematurely. We recom-
mend that you do not put sharp-tipped instruments (such as splinter forceps) inside your nylon hol-
ster. If, however, you find it necessary to carry a sharp-tipped instrument, place a protective cover
(such as a plastic pen cap) over the tips.
To convert your snap-on belt loop to a permanent belt loop
if you do not require the convenience of a snap-on belt loop, and instead prefer the security of a per-
manent loop you can convert your ADC® nylon holster as follows:
1. Obtain a “super glue” or epoxy at your localm convenience store.
2. Making sure snaps are clean and dry; apply 2 or 3 drops to the male portion of each snap, along
the rim and outer edge.
3. Snap both snaps closed and allow glue to set according to the directions on the glue package.
4. Test that glue snaps hold. If either snap doesn’t hold repeat the process.
Use of your ADC Knife:
Selected holster sets are equipped with the ADTOOL™ multifunction tool or Puma lockback knife.
Both feature blades forged from 440 surgical stainless steel, tempered to a Rockwell hardness of
C57-59.
The ADTOOL™ includes pliers, wire cutters, 2" knife blade, 3 flathead screwdrivers of varying sizes, a
can opener, 2" serrated blade, bottle opener, and Phillips head screwdriver. To use pliers grip handles
from either side, and pry apart fully. To access all other components grip handles from either side and