American Access Systems Advantage DG - Raintight Unit - 23-2000rt - Manual (Page 4)

Page 4 American Access Systems / Security Brands, Inc.
BEFOrE PrOCEEDING
To take full advantage of the 24 month limited warranty, you must be registered with American Access SystemsS.
Please read the enclosed warranty statement, (pg 2), fill out the warranty registration card provided and send it to:
1675 West Yale Ave.
Englewood, CO 80110
phone: 303-799-9757
fax: 303-799-9756
[email protected]
www.securitybrandsinc.com
SECURITY BRANDS INC
INTrODUCTION
Your new PROX 2000 II unit is a high quality, programmable, commercial digital key control station. The unit
incorporates an interface for two remote wiegand card readers as well as an interface for a serial printer. The PROX
2000 II unit also employs a history buffer which stores up to 1000 transactions. A true Anti-passback feature is also
provided for the end user. The unit incorporates 2 relays on the circuit board. The relay outputs can be programmed
in 1 of 2 ways:
* All PROXIMITY CARDS entered into the system will operate relay A (Default setting).
* All PROXIMITY CARDS entered on PROX 1 will operate relay A, and all cards entered on PROX 2 will operate relay B
(SPLIT RELAY FEATURE).
The relay output times are user selectable from 1 to 99 seconds and provide a normally open (N/O) and normally
closed (N/C) output. Make sure to read and understand all instructions before proceeding with each step.
STEP 1-MOUNTING THE SLAVE UNITS
Mounting the unit to your own pedestal
Your slave units come with a square mounting flange found in the bottom of the box along with four carriage bolts
and four hex nuts. The square mounting flange may be welded to your pedestal and the flange bolt pattern will align
with the back of the unit. Place the unit up to the flange and insert the carriage bolts from the back side. Secure the
unit to the flange by tightening down the hex nuts with a 7/16” socket.
Mounting the unit to an AAS gooseneck (18001) or double height (18003)pedestal
Locate the four carriage bolts and four hex nuts found inside the unit box. Place the unit up to the pedestal flange
and insert the four carriage bolts from the backside. Secure the unit to the pedestal using the four hex nuts and a
7/16” socket. The extra square mounting flange may be discarded.