Allersearch Hippo Deluxe - Manual (Page 7)

6
TROUBLE SHOOTING
PROBLEM
The switch is ON, but the
Operation indicator lamp (ON)
is off
No Mist
Condensation forms around
the humidifier or windows
Empty water level indicator
lamp (EMPTY) illuminates
Water overflows from the tank
CAUSE
Unit is not plugged in.
No power at the outlet.
No water in the reservoir.
Unit is not level.
Mineral deposits are on the
Heater or Removable Heat
Cone.
Water Reservoir was washed
with detergent.
Mist intensity is too high for the
room size or pre-existing
humidity level.
Water Reservoir is empty.
The unit was not switched off
and let cool after refilling the
water reservoir.
T h e h e a t i n g e l e m e n t i s
encrusted with scale and the
protection thermostat has
tripped.
Tank may be leaking.
Tank Cap is loose.
SOLUTION
Plug the unit in.
Have the circuits, fuses, and
test outlet with a tester.
Fill reservoir with water.
Place on a level surface
Clean the Heater and
Removable Heat Cone as
specified in the Weekly
maintenance.
Rinse thoroughly with clean
water and dry.
Open room door gradually
until condensation stops.
Refill water reservoir
Disconnect the power cord.
Switch off the unit, and let it
cool off for 15 minutes. Then
switch the unit on.
Unplug the power cord and
c a r r y o u t t h e c l e a n i n g
procedure.
Check before every usage
that the lid of the tank is
securely closed, that the tank
has no cracks or damages,
and that the membrane valve
closes properly.
Tighten the Tank Cap.