Advanced Elements AE1008 User Manual

Page 10

Deflate

Inflate

Figure 3. Inflate/Deflate Boston Valve

To begin inflating your kayak, you will need a Bellows Foot Pump or a Double Action Hand
Pump. Never use compressors, CO2 or compressed air as they may damage your kayak.

Diagram of Inflation Chambers

3.3 Inflating

IMPORTANT: Before inflating, check to be sure that the canoe is completely assembled. Inflate
your canoe in the following order. Failure to follow these instructions may cause damage to
your canoe. Do not over inflate.

1. Locate chamber 1 (floor). Attach pump hose to valve and Inflate until firm (1.0 psi ONLY).
Position in the center of the canoe (CAUTION: Do not over inflate).

2. Proceed to chamber 2 and 3. (Bow and Stern Bags) Inflate until firm (1.5 psi ONLY).
3. Locate chambers 4 and 5 right and left “side tubes”. Check to be sure spring valve is in the
inflate position (See Figure 1). Inflate chambers until firm (1.5 psi ONLY). Do not over inflate.
4. Locate Chambers 6 and 7 (seat cushions). Inflate Chambers to desired firmness (Max 1.5 psi).